Used as directed, Reef Builder™ will not deplete calcium, magnesium, or strontium which usually tend to precipitate with increasing alkalinity. Reef Builder™ and Reef Buffer™ may be used together. Use Reef Builder™ to raise carbonate alkalinity without affecting pH. Use Reef Buffer™ to raise carbonate alkalinity and pH.

Sizes: 50 g, 250 g, 500 g, 1 kg, 4 kg, 20 kg

Why It's Different
Unlike the competition, Reef Builder™ contains calcium, magnesium, and strontium to compensate for the inevitable loss which occurs when raising alkalinity. It also contains sufficient magnesium to restore magnesium routinely depleted.

Directions
BEGINNER: Use 3 g (half a level teaspoon*) per 150 L (40 gallons) twice a week. Dissolve in at least 250 mL (1 cup) of freshwater. Check alkalinity every 2 weeks and adjust amount or frequency accordingly.

ADVANCED: Check alkalinity, then follow addition regimen above until alkalinity is adjusted to 4–5 meq/L. Each 3 g/150 L will raise alkalinity by about 0.25 meq/L. Quantity or frequency can be adjusted, but do not exceed 12 g/150 L per day. Thereafter, use as required to maintain alkalinity.

EXPERT: After determining the alkalinity consumption rate, set up a continuous drip system. Use the following formula to determine how much to add to your top-off water: m=0.08va (m=grams to add to top off water, v=volume of tank in liters, a=amount to raise alkalinity in meq/L). For example, if you want to raise your alkalinity by 1 meq/L in a 200 liter tank, then you would add 0.08x200x1=16 g into the top-off water. [For reference: 1 gallon*=3.8 liters, 6 g=1 teaspoon*]. Notes: Use MultiTest:™ Marine pH & Alkalinity to measure total alkalinity