Copper test Salifert

Silicate Test Salifert Silicate occurs especially in tap water or in purified water when the RO or DI unit is not functioning properly. Silicate not only results in diatom bloom but might also block some essential trace elements such as vanadium and molybdenum. Salifert offers a very sensitive and accurate silicate test kit. Silicate content can be...

Ammonia (NH3) Test Salifert Ammonia and ammonium are substances which should be converted rapidly into nitrite followed by nitrate and nitrogen gas. If this does not happen then the aquarium is not fully cycled or biological processes are not proceeding as they should. The Salifert Ammonia test is very straightforward and measures the sum...

Magnesium test (mg) Salifert Magnesium is present in NSW in a fairly high concentration (1300 - 1400 mg/L). Magnesium is an essential part of chlorophyll, which is necessary for photosynthesis. Without photosynthesis plants, including algae and the corals, which we usually have in our aquariums, would not be able to live.

NO3 test Salifert

NO2 test Salifert

Phosphate test (PO4) Salifert

KH test Salifert

pH test Salifert

Calcium test (Ca) Salifert

Apogee Protective carrying case Protective carrying case designed to transport and store Apogee meters, sensors, and accessories. Please note, this case does not fit the AM-320 underwater wand. It will fit a AM-310 telescopic wand, but that wand is not recommended for underwater use. Dimensions (LxWxH): Width approx. 27 cm Height approx. 16,5...

PAR meter MQ-510 The MQ-510 quantum meter is designed for underwater PAR measurements and already applies the sensor's immersion effect correction factor to the meter readings through firmware. The meter consists of a waterproof quantum sensor attached via waterproof cable to a handheld meter. The waterproof sensor incorporates a blue-enhanced silicon photodiode...