Black/neon green frags holder Methacrylate frag holder suitable for 18 cuttings, Neodymium magnets high quality, the interiors lined in rubber to prevent rust. Measurements: 270x60x40 mm. - Maximum glass: 12 mm.

White/neon red frags holder Methacrylate frag holder suitable for 18 cuttings, Neodymium magnets high quality, the interiors lined in rubber to prevent rust. Measurements: 270x60x40 mm. - Maximum glass: 12 mm.

1x disk  for Spin TouchFF marine

Apogee Protective carrying case Protective carrying case designed to transport and store Apogee meters, sensors, and accessories. Please note, this case does not fit the AM-320 underwater wand. It will fit a AM-310 telescopic wand, but that wand is not recommended for underwater use. Dimensions (LxWxH): Width approx. 27 cm Height approx. 16,5...

50x disks for Spin TouchFF marine

Spin TouchFX photometer The new WaterLink Spin TouchFF photometer does all the freshwater or seawater analyzes for you. The Spin TouchFF uses special sealed test discs that contain the precise amount of reagent needed to perform a complete series of tests. The discs are available for freshwater and saltwater. Sea water: Alkalinity, Nitrite, Nitrate,...

PAR meter MQ-510 The MQ-510 quantum meter is designed for underwater PAR measurements and already applies the sensor's immersion effect correction factor to the meter readings through firmware. The meter consists of a waterproof quantum sensor attached via waterproof cable to a handheld meter. The waterproof sensor incorporates a blue-enhanced silicon photodiode...