Oceamo Lab RO Water analysis The suitability of tap water for aquaristic use can also be checked with this analysis. At Oceamo, these samples are given full attention: because problems often arise in the reef tank already during the treatment of the source water. Our instruments are specially calibrated for your pure water samples, and we examine your sample for all...

ICP-MS Seawater Analysis (sea water) Use the ICP-MS analysis to get a much more detailed view of pollutants and trace elements in your reef aquarium. With the Oceamo ICP-MS Analysis, your seawater analysis is performed with ICP-MS (instead of ICP-OES). ICP-MS (ICP with mass spectrometry) is significantly more sensitive and offers up to 10,000 times lower detection...

Oceamo Lab Classic Water analysis Use our Oceamo Lab Classic analysis to determine all essential chemical parameters in the reef aquarium: Oceamo Seawater analysis Basic parameters:       alkalinity, salinity Macro elements:         boron, bromide, calcium, chloride, potassium, magnesium, sodium, strontium, sulfate Trace elements:          barium,...

Areometer 260mm with measuring cylinder

Aquaria protection gloves 90cm (x10) - Lenght 90cm - With arm protection - Protection against water and cnidarians.

Apogee Protective carrying case Protective carrying case designed to transport and store Apogee meters, sensors, and accessories. Please note, this case does not fit the AM-320 underwater wand. It will fit a AM-310 telescopic wand, but that wand is not recommended for underwater use. Dimensions (LxWxH): Width approx. 27 cm Height approx. 16,5...

PAR meter MQ-510 The MQ-510 quantum meter is designed for underwater PAR measurements and already applies the sensor's immersion effect correction factor to the meter readings through firmware. The meter consists of a waterproof quantum sensor attached via waterproof cable to a handheld meter. The waterproof sensor incorporates a blue-enhanced silicon photodiode...

Reefbot V2 ReefBot uses traditional reagent based method to autonomously measure the levels of the most common parameters in your tank. It currently measures Alkalinity (Alk), Calcium (Ca), Magnesium (Mg), Nitrate (NO3), Phosphate (PO4), Nitrite (No2), Ammonia (NH3), Copper (Cu) and Iodine (I2) with more parameters added regularly. Upgraded features<br...

Areometer 260mm