The filter has a filtration capacity of 15.9 liters (4.2 gallons) and a highly efficient, energy-efficient pump. Together with its electronic control, it will be very easy for you to manage large capacity aquariums, more specifically from 190 liters to 1515 liters.

Its set of 2 inlet hoses and 2 outlet hoses guarantee adequate water circulation throughout the aquarium, effectively avoiding the formation of dead zones.

Aquael products guarantee a high level of safety and Hypermax is not far behind, it works with a 24 volt voltage. In the event of a rotor blockage, the device will turn off automatically, thus preventing the consequences of the failure from aggravating. In addition, we will be notified of the event by an acoustic signal and the flashing of the function LEDs.

Hypermax will react the same way in the event of a missing rotor in the motor chamber.

An easy, comfortable and intuitive design has been ensured from the user-friendly control panel to the wheels that allow you to move the appliance comfortably. Proven and patented functionalities, previously used in the renowned ULTRAMAX filters, have also been applied. These include a pre-filter and systems: double ball valves and auto-flooding of the filter.

PREFILTER

The large-capacity pre-filter built into the lid of the appliance effectively retains large impurities, which considerably reduces the frequency of filter maintenance. Cleaning the pre-filter itself is very simple and does not even require removing the appliance from the casing. Just lift the lid, take the sponge out of the basket and rinse it under the tap.

 

It is known that when it comes to accessing the inside of the filter and disconnecting the inlet and outlet hoses, it is not an easy task. The remaining water in the filter often spills onto the floor, causing justifiable irritation. To prevent this, the Hypermax uses a patented double ball valve system. They simultaneously close the inlet and outlet of the filter in the lid and the hose space and prevent the uncontrolled escape of water.

 

Just make 2 to 4 plunger movements and you're done. The filter will be flooded with water from the aquarium.

Included in the box is a set of accessories needed to install and start up the filter: